China Suppliers Factory for 96W Series IP67 Waterproof Power Supply - Reliable and High-Quality Solutions

The range of input voltage is from 90Vac to 264Vac with a single phase.

Input AC Current: 2.3A max @ 100-240Vac input & Full load.

Inrush Current (cold start): The inrush current will not exceed 120A at 240Vac input and Max load for a cold start at 25℃.

Average Efficiency: While input 115Vac and 230Vac, the average efficiency is more than 86.0%. The test point is at 25%, 50%, 75% and 100% of max load respectively.

Energy Consumption: While input 115Vac or 230Vac and the output is no load, the input power loss must be less than 0.21W.

Turn-on Delay Time: 3S max @ 100 Vac to 240 Vac input & Full load.

Hold-up Time: 5mS min @ Full load & 230Vac/50Hz input turn off at worst case.

Capacitance Load: While input 100~240Vac and capacitance load is 470uF, the adapter can turn on normally and the output is in the rated range.

Output Overshoot / Undershoot: 10% max when the power on or off.

Output Load Transient Response: The output shall not exceed 10% of the nominal output voltage, load fluctuation: from 20% to 80%, R/S: 0.5A/uS, frequency: 100Hz duration and 8mS at 80%.

Over Current Point Limited: 4.5-8A, The output shall hiccup when the over currents applied to the output rail, and shall be self-recovery when the fault condition is removed.

Short Circuit Protection: The input power shall decrease when the output rail short, the power supply shall no damage, and shall be self-recovery when the fault condition is removed.

Over Voltage Protection: The power supply shall protection when the output over voltage.

Operating Temperature and Relative Humidity: 0°C to +40°C, 10%RH to 90%RH.

Storage Temperature and Relative Humidity: -20°C to +80°C, 5%RH to 95%RH non-condensing @ Sea level shall be low 10,000 feet.

Vibration: 10 to 300Hz sweep at a constant acceleration of 1.0G (Breadth: 3.5mm) for 1 Hour for each of the perpendicular axes X, Y, Z.

Waterproof Test: IP67 Reference standard, Maximum operation humidity is 98%. It is recommended to operate in conditions under RH 90%. The nozzle with an inner diameter of 12.5mm is used to make the distance between the test sample and the nozzle 2.5m ~ 3m, and the water flow rate is 100 L/min (6000 L/h). According to the shell surface area of the tested sample, it is 1 min per square meter (excluding the installation area) and at least 3 min. Vacuum test: vacuum suction pressure 3Kg/F (equivalent to water depth of 30 meters) for 3S with no air leakage detected.

Reliability Requirements: The power supply shall be burn-in at least 4 Hours under normal input and 80% rated load at 40℃ ± 5℃. The MTBF shall be at least 50,000 hours at 25°C, Full load and nominal input condition.

Dielectric Strength (Hi-pot): Primary to Secondary: 4242VDC or 3000VAC / 5mA Max / 60 seconds (3 seconds for mass production).

Leakage Current: 0.25mA max at 264Vac / 50Hz.

Insulation Resistance: 50MΩ min at primary to secondary add 500Vdc test voltage.